fix it

It is assigned to a different output . Fix: The knob drives one output at a time. Press the button for the output you are listening to.

The knob is locked . Fix: Holding the lit output button disables it. Hold again to unlock.

A Clone block sits before them . Fix: Every Clone is mono and sums anything stereo in front of it. Move stereo effects after the clone.

Nothing on the microSD card . Fix: Song tracks live on the card under the security panel. It ships fitted, and if it has been removed, Showcase has nothing to read.

A different footswitch mode . Fix: Press MODE for your two main modes. Hold it for all of them, including Combo and Transport.

The left column is set to song or marker . Fix: Hold FS1 + FS7 to cycle it back to bank or preset.

An input or output block is clipping . Fix: Blocks turn bright red when they clip. Find the red one. There is no other meter.

The input needs its pad . Fix: Each INSTRUMENT input has a switchable pad, impedance and gate before any block.

A hard cap . Fix: Four amps or preamps per preset, two per path. Four clones, two per path. Eight cabs, four per path. Two poly effects per path.

Clones and Agoura amps are expensive . Fix: Two of either on one path plus effects will fill it. Move blocks to the other path.

The cable is in USB A . Fix: USB A is a host port for an Ethernet adapter. The computer goes in USB C.

Snapshot Edits is set to Discard . Fix: Global Settings > Preferences > Snapshot Edits sets this. Recall (the default) keeps your changes as you left them. Discard returns the snapshot to its last-saved state. Discard suits playing live and loses edits while you are building. Hold BYPASS and press SAVE to flip it at any time. The camera icon on the Home screen is gray for Recall and red for Discard.

Nothing has been changed in it yet . Fix: An unedited snapshot carries the state you arrived with. It becomes its own sound the moment you change something in it. Nothing is broken.

It recalls whichever snapshot was active when the preset was saved . Fix: Saving a preset stores all of its snapshots and remembers which one you were on. If a song should always start on the intro sound, select that snapshot and then save. The choice is made at save time, not at load time.

Snapshot Mode Switches is set to Auto Return . Fix: Set Global Settings > Footswitches > Snapshot Mode Switches to Manual Return and it stays in snapshot mode until you press CANCEL. Auto Return suits occasional snapshot use. Manual Return suits a set played on snapshots.

That block's Trails setting is Off . Fix: Trails Off mutes repeats and decays the moment the block is bypassed. Trails On lets them ring out, through a bypass and through a snapshot change. It is set per block, so check every delay and reverb.

No—Line 6 flag this in capitals, twice . Fix: Never connect these XLR outputs to a device whose XLR inputs have 48V phantom power enabled. On a desk, that means switching phantom off for those channels before you plug in, not after.